Perry the Platypus Cake
Leave it to the tri-state area’s resident Platypus to find yet another way to go undercover — this time as an eye-popping party cake.
prep time 20 mins
cook time 35 mins
total time 55 mins
Working on a wax paper-covered cake board or tray, spread an initial coat of teal frosting on the carved cake, just thick enough to seal in the crumbs. Chill the cake for 30 minutes to harden the frosting.
Meanwhile, break one of the graham crackers in half and use a knife to carefully round the front edges, as shown. You'll use both of these to create a double-thick bill. Leave the other two graham crackers whole to use for the tail.
Melt about a third of the package or so of orange easy-to-melt candy wafers as directed on the package. Working on a sheet of wax paper, quickly spread a dab of the melted candy on the back of one of the tail crackers and stick the matching cracker to it to create a double-layered piece. Do the same with the bill crackers. Now spread the melted orange candy on the tops of the tail and bill, and give them a few minutes to set up. Melt more easy-to-melt candy wafers to spread on the flip sides of the crackers. When the final coating of candy sets up, score a crisscross pattern on the tail.
Create eyes by using a bit of frosting to stick a brown hard shelled chocolate candy atop each of the white easy-to-melt candy wafers.
Spread a second coat of frosting on the cake. Use a damp paper towel to carefully wipe any excess frosting and crumbs from the wax paper around the perimeter of the cake. Then you can trim the paper close to the cake edge, if you like.
Set the candy-coated platypus bill in place at the front of the cake and gently push the straight end into the frosting. Place the tail upright at the back of the cake, pressing the base into the frosting. (Tip: If needed, you can use a circus peanut candy to prop the tail from behind.) Press the eyes into the icing at the front corners of the cake.
For each of Perry's webbed back feet, flatten a orange marshmallow candy with a rolling pin. Then slice the side that will go next to the cake at an angle, as shown.
Set the feet in place. Lastly, cut or shape the teal candies to resemble Perry's thin front legs and set them in place near the front of the cake